Features
- Compatibility: ONLY Compatible with Security+ 2.0 LiftMaster garage door openers that are enabled by myQ technology and have a round yellow learn button and two yellow antennas
- Installation: Wired connection required during installation for power source. Connect these wires to the back of the door control and the garage door opener. Please note that this product is not battery powered
- Confirm Correct Installation: Plug in the garage door opener and reconnect the battery. The command LED on the door control will blink if installed correctly. To synchronize the garage door opener and the door control, press the push bar up to 3 times, until the garage door opener activate
- Program Remote Control: 1. Press the LEARN button on the door control twice. The Command LED will blink. 2. Press and release the button on the remote control that you wish to operate your garage door. The garage door opener lights will flash (or two clicks will be heard) and the Command LED will stop blinking when the code has been programmed correctly
- Programming Guideline: 1. Lift the push bar on the door control. Press and release the LEARN button. The garage door opener will beep once and the command LED on the door control will blink to indicate Wi-Fi learn mode 2. On your mobile device, go to Settings > Wi-Fi and select the network with the “MyQ-” prefix 3. Launch the web browser on your smartphone or tablet. Enter setup.myqdevice.com into the browser address bar. The MyQ serial number will display on screen. Write the serial number in the space below 4. Sign up for your MyQ account and add the MyQ serial number to your account. If you are unsuccessful adding your device, try an alternate web browser or visit WiFiHelp.LiftMaster.com
*If this is not the "
LiftMaster 882LM Security+ 2.0 Multi-Function Control Panel" product you were looking for, you can check the other results by
clicking this link
.
Details were last updated on Mar 8, 2026 15:57 +08.
.
Details were last updated on Mar 8, 2026 15:57 +08.
