KUNCAN 2FT SAE to O Ring Terminal Harness Wire 2 Pin Lug Cable, Eyelet Terminal Harness Ex

Product Description

Feature:
Much better than having to find an allen wrench to open the battery door then try to clamp those alligator clips onto the battery.
The length is perfect to hide the charging end behind the rear brake reservoir. These little ring terminal harnesses are super handy to have installed on your most charged devices.
These are a must-have for old carbureted motorcycles, sticking them on my modern bikes. It is worth having one of these on every battery in your garage.
There is no need to lift the seat but still trickle charge, as you can leave it attached and tucked it in under the seat.
Use to charge battery with an accessory connector (and a USB charger) to recharge your devices, or run an air pump.
Fast and easy to connect and disconnect, you can to install on your battery for quick connection to the battery maintainer.
This is the best way to keep a battery charged on a car, or used it to keep the battery fully charged on the emergency generator.

Ring Terminal to SAE :
Molded 45P PVC Black
Molded PE Transparent
Female Bullet Terminal: 4.57mm Rec, Nickel Plated Brass
Male Bullet Terminal: 4.57mm Pin, Nickel Plated Brass

Ring Terminal :
Molded PVC Black 45P
Molded PE Black 45P
Terminal: 8.4*13.8 R Type, Brass

Fuse case :
Molded PVC Black 45P
Molded PE Transparent
Car Fuse: 10A
Terminal: 205 Female Type, Nickel Plated Brass

Cable:
SPT-2 16AWG/2C
Red/Black
Length: 2ft
OD: 3.7*7.4mm

Package:
1 pcs

Customers Who Bought This Item Also Bought

*If this is not the "KUNCAN 2FT SAE to O Ring Terminal Harness Wire 2 Pin Lug Cable, Eyelet Terminal Harness Extension Ch" product you were looking for, you can check the other results by clicking this link.  Details were last updated on Jul 2, 2024 00:34 +08.