Ham It Up Plus - HF/MF/LF/VLF/ULF Upconverter w/TCXO & Separate Noise Source Circuit. Full

Product Description

For full product details and specifications, please visit the product page at nooelec.com

Major differences vs. Ham It Up v1.3:

• A 125MHz TCXO, custom built for exclusively for NooElec by our Japanese partner, is included and pre-installed, providing more accurate and stable tuning in any environment
• Ultra-low distortion ceramic capacitors, custom built exclusively for NooElec by our Taiwanese partner, allowed us to extend the range of the Ham It Up Plus all the way down to 300Hz
• The separate noise source circuit is fully assembled, which can be used for a number of RF projects, including calibration and tuning of filters, amplifiers and attenuators
• Form factor was kept identical to the Ham It Up, which means the same enclosure can be used (note a new end panel may be required to accommodate the additional SMA connector of the noise source circuit)

Operation:

• Connect your antenna to the RF input
• Connect your SDR to the IF output
• Ensure your toggle switch is in the enable position
• Plug your USB power source into the USB-B USB jack
• Fire up your favorite SDR software. Tune to 125MHz + (+/- the tuning offset from the tuning procedure) + your desired frequency and enjoy!

*If this is not the "Ham It Up Plus - HF/MF/LF/VLF/ULF Upconverter w/TCXO & Separate Noise Source Circuit. Fully Assemble" product you were looking for, you can check the other results by clicking this link.  Details were last updated on Jun 18, 2024 04:25 +08.